无托槽隐形矫治器腭侧边缘不同延伸长度在拔牙病例中力学特点的三维有限元分析

doi:10.13701/j.cnki.kqyxyj.2024.11.004

摘要/Abstract

摘要： 目的: 通过三维有限元分析探讨无托槽隐形矫治器不同腭侧边缘延伸长度在拔牙病例中内收前牙时的牙列移动特点。方法: 构建无托槽隐形矫治器三维有限元模型,依据不同第二前磨牙区腭侧边缘延伸长度分为4组工况:龈上1 mm、齐龈、延长1 mm及延长2 mm,分析4组工况下牙齿移动特点及牙周膜应力。结果: 所有工况中,均表现为切牙舌倾伸长、尖牙远中倾斜及后牙近中倾斜。随腭侧边缘长度的增加,中切牙矢状向倾斜程度在工况4时最小,侧切牙在工况2时最小;尖牙远中位移量依次增加,舌倾位移量依次减小,伸长位移量在工况1~3时增加,工况4时减小;第二前磨牙近中及压低位移量在工况1~3时少量增加,工况4时减小;第一磨牙近中压低位移量依次增加。牙周膜等效应力表现为尖牙根尖区应力峰值最大。结论: 无托槽隐形矫治器在拔牙病例内收上前牙时会出现过山车现象,边缘长度增加有利于切牙整体移动,但尖牙远中倾斜趋势增加,当膜片延长超过1 mm时可防止尖牙舌倾伸长及第二前磨牙近中倾斜,同时对第一磨牙支抗要求更高。

关键词: 三维有限元, 无托槽隐形矫治器, 拔牙矫治, 正畸间隙闭合

Abstract: Objective: To investigate the displacement of dentition during retraction of anterior teeth under different palatal edge extension of clear aligners in extraction cases. Methods: A finite element model was constructed to analyze the characteristics of tooth movement and periodontal membrane stresses of clear aligners. The model was based on different palatal edge extension and classified into four cases: working condition 1: supergingival 1 mm, working condition 2: flanking gingival, working condition 3: extended 1 mm, and working condition 4: extended 2 mm. Results: Clear aligners therapy caused lingual tipping and extrusion of incisors, distal tipping of canines, and mesial tipping of posterior teeth in each group. With increasing palatal edge length, the degree of sagittal inclination was gradually decreased in central incisors and the lateral incisors were minimized at work condition 2. The distal tipping of the canine increased gradually, lingual tipping gradually decreased, and extrusion displacement increased in working conditions 1 to 3 and decreased in working condition 4. The medial tipping and intrusion of the second premolar initially increased and tended to decrease in condition 4. The mesial tipping and intrusion of the first molar were gradually increased. The Mises stresses exhibited the highest peak stresses in the apical region of the cusps. Conclusion: Clear aligners can be a roller coaster when retracting upper anterior teeth in extraction cases, extending the palatal edge can facilitate the bodily movement of incisal, but the canine distal tipping displacement increased. If the edge length exceeds 1mm, it can effectively prevent the canine lingual inclination and extrusion, and the second premolar medial inclination. However, there is a need of greater anchorage to support the first molar.

Key words: finite element analysis, clear aligner, extraction orthodontics, orthodontic space closure

王江婷, 陈梅, 张瑞晶, 刘林毅, 佘芮, 温秀杰. 无托槽隐形矫治器腭侧边缘不同延伸长度在拔牙病例中力学特点的三维有限元分析[J]. 口腔医学研究, 2024, 40(11): 960-966.

WANG Jiangting, CHEN Mei, ZHANG Ruijing, LIU Linyi, SHE Rui, WEN Xiujie. Biomechanical Effects of Clear Aligners with Different Palatal Edge Extension in Extraction Cases: A Three-dimensional Finite Element Study[J]. Journal of Oral Science Research, 2024, 40(11): 960-966.

参考文献

[1] AlMogbel A. Clear aligner therapy: Up to date review article [J]. J Orthod Sci, 2023, 12:37.
[2] Guo Z, Zhang R, Guo C, et al. A retrospective study of alveolar bone remodelling after anterior retraction in orthodontic tooth extraction cases with clear aligners and fixed appliances [J]. Orthod Craniofac Res, 2024, 27(2):220-227.
[3] Dai FF, Xu TM, Shu G. Comparison of achieved and predicted crown movement in adults after 4 first premolar extraction treatment with Invisalign [J]. Am J Orthod Dentofacial Orthop, 2021, 160(6):805-813.
[4] Dai FF, Xu TM, Shu G. Comparison of achieved and predicted tooth movement of maxillary first molars and central incisors: First premolar extraction treatment with Invisalign [J]. Angle Orthod, 2019, 89(5):679-687.
[5] Jin X, Tian X, Lee Zhi Hui V, et al. The effect of enhanced structure in the posterior segment of clear aligners during anterior retraction: a three-dimensional finite element and experimental model analysis [J]. Prog Orthod, 2024, 25(1):3.
[6] Feng X, Jiang Y, Zhu Y, et al. Comparison between the designed and achieved mesiodistal angulation of maxillary canines and posterior teeth and influencing factors: First premolar extraction treatment with clear aligners [J]. Am J Orthod Dentofacial Orthop, 2023, 164(4):464.
[7] Liu L, Song Q, Zhou J, et al. The effects of aligner overtreatment on torque control and intrusion of incisors for anterior retraction with clear aligners: A finite-element study [J]. Am J Orthod Dentofacial Orthop, 2022, 162(1):33-41.
[8] Wang S, Huang Y, Fan D, et al. Effects of overtreatment with different attachment positions on maxillary anchorage enhancement with clear aligners: a finite element analysis study [J]. BMC Oral Health, 2023, 23(1):693.
[9] Cheng Y, Liu X, Chen X, et al. The three-dimensional displacement tendency of teeth depending on incisor torque compensation with clear aligners of different thicknesses in cases of extraction: a finite element study [J]. BMC Oral Health, 2022, 22(1):499.
[10] Liu L, Zhan Q, Zhou J, et al. Effectiveness of an anterior mini-screw in achieving incisor intrusion and palatal root torque for anterior retraction with clear aligners [J]. Angle Orthod, 2021, 91(6):794-803.
[11] Elshazly TM, Keilig L, Salvatori D, et al. Effect of trimming line design and edge extension of orthodontic aligners on force transmission: An in vitro study [J]. J Dent, 2022, 125:104276.
[12] Elshazly TM, Salvatori D, Elattar H, et al. Effect of trimming line design and edge extension of orthodontic aligners on force transmission: A 3D finite element study [J]. J Mech Behav Biomed Mater, 2023, 140:105741.
[13] Lyu X, Cao X, Yan J, et al. Biomechanical effects of clear aligners with different thicknesses and gingival-margin morphology for appliance design optimization [J]. Am J Orthod Dentofacial Orthop, 2023, 164(2):239-252.
[14] Liu JQ, Zhu GY, Wang YG, et al. Different biomechanical effects of clear aligners in bimaxillary space closure under two strong anchorages: finite element analysis [J]. Prog Orthod, 2022, 23(1):41.
[15] Cao Y, Wang ZW, Chen D, et al. The effect of space arrangement between anterior teeth on their retraction with clear aligners in first premolar extraction treatment: a finite element study [J]. Prog Orthod, 2023, 24(1):39.
[16] Gao L, Wichelhaus A. Forces and moments delivered by the PET-G aligner to a maxillary central incisor for palatal tipping and intrusion [J]. Angle Orthod, 2017, 87(4):534-541.
[17] Clements KM, Bollen AM, Huang G, et al. Activation time and material stiffness of sequential removable orthodontic appliances. Part 2: Dental improvements [J]. Am J Orthod Dentofacial Orthop, 2003, 124(5):502-508.
[18] Zhu Y, Li X, Lai W. Treatment of severe anterior crowding with the invisalign G6 first-premolar extraction solution [J]. J Clin Orthod, 2019, 53(8):459-469.
[19] Meng X, Wang C, Xu W, et al. Effects of different designs of orthodontic clear aligners on the maxillary central incisors in the tooth extraction cases: a biomechanical study [J]. BMC Oral Health, 2023, 23(1):416.
[20] Cheng Y, Gao J, Fang S, et al. Torque movement of the upper anterior teeth using a clear aligner in cases of extraction: a finite element study [J]. Prog Orthod, 2022, 23(1):26.
[21] Yang Y, Yang R, Liu L, et al. The effects of aligner anchorage preparation on mandibular first molars during premolar-extraction space closure with clear aligners: A finite element study [J]. Am J Orthod Dentofacial Orthop, 2023, 164(2):226-238.
[22] 唐昕月,须敏依,华滢婕,等.无托槽隐形矫治上颌前牙分步内收和整体内收的三维有限元分析[J].中华口腔医学杂志,2023,58(7):669-675.
[23] Sawamura M, Nakano H, Shiogama M, et al. Using digital image correlation to measure displacement and strain during involving distal movement of anterior teeth with clear aligner [J]. Dent Mater J, 2023, 42(4):493-500.
[24] 康芙嘉,张茜雅,余磊,等.微种植体辅助无托槽隐形矫治器压低上颌前牙的三维有限元分析[J].口腔医学,2023,43(9):796-802.
[25] Gomez JP, Peña FM, Martínez V, et al. Initial force systems during bodily tooth movement with plastic aligners and composite attachments: A three-dimensional finite element analysis [J]. Angle Orthod, 2015, 85(3):454-460.
[26] Lund H, Gröndahl K, Hansen K, et al. Apical root resorption during orthodontic treatment. A prospective study using cone beam CT [J]. Angle Orthod, 2012, 82(3):480-487.
[27] Lee BW. Relationship between tooth-movement rate and estimated pressure applied [J]. J Dent Res, 1965, 44(5):1053.
[28] 孟雪欢,王春娟,王超,等.无托槽隐形矫治整体内收减数正畸患者前牙的三维有限元分析[J].中华口腔医学杂志,2019,54(11):753-759.